G Codes GSK983M S/V Drillling & Milling CNC System
G Codes GSK983M
| G Code | Function |
|---|---|
| G00 | Positioning |
| G01 | Linear interpolation |
| G02 | Circular interpolation (CW) |
| G03 | Circular interpolation (CCW) |
| G04 | Dwell |
| G05 | High-speed continuous cutting mode |
| G07 | Federate sine curve control |
| G09 | Exact stop check |
| G10 | Offset value setting, start of registration of tool life management data |
| G11 | End of registration of tool life management data |
| G17 | XY plane selection |
| G18 | ZX plane selection |
| G19 | YZ plane selection |
| G20 | Input in inch |
| G21 | Input in mm |
| G22 | Stored stroke limit ON |
| G23 | Stored stroke limit OFF |
| G27 | Reference point return check |
| G28 | Return to reference point |
| G29 | Return from reference point |
| G30 | Return to 2 nd , 3 rd , 4 th reference point |
| G31 | Skipping cutting |
| G33 | Thread cutting |
| G40 | Cutter compensation cancel |
| G41 | Cutter compensation left |
| G42 | Cutter compensation right |
| G43 | Tool length compensation + direction |
| G44 | Tool length compensation – direction |
| G49 | Tool length compensation cancel |
| G45 | Tool offset increase |
| G46 | Tool offset decrease |
| G47 | Tool offset double increase |
| G48 | Tool offset double decrease |
| G50 | Scaling off |
| G51 | Scaling on |
| G54 | Workpiece coordinate system 1 select |
| G55 | Workpiece coordinate system 2 select |
| G56 | Workpiece coordinate system 3 select |
| G57 | Workpiece coordinate system 4 select |
| G58 | Workpiece coordinate system 5 select |
| G59 | Workpiece coordinate system 6 select |
| G60 | Single directional positioning |
| G61 | Exact stop check mode |
| G62 | Automatic corner override |
| G64 | Cutting mode |
| G65 | Custom macro simple call |
| G66 | Custom macro modal call |
| G67 | Custom macro modal call cancellation |
| G73 | Peck drilling cycle |
| G74 | Counter tapping cycle |
| G76 | Fine boring |
| G80 | Canned cycle cancel |
| G81 | Drilling cycle, spot boring |
| G82 | Drilling cycle, counter boring |
| G83 | Peck drilling cycle |
| G84 | Tapping cycle |
| G85 | Boring cycle |
| G86 | Boring cycle |
| G87 | Back boring cycle |
| G88 | Boring cycle |
| G89 | Boring cycle |
| G90 | Absolute programming |
| G91 | Incremental programming |
| G92 | Absolute zero programming |
| G94 | Per minute feed |
| G95 | Per revolution feed |
| G98 | Return to initial point in canned cycle |
| G99 | Return to R point in canned cycle |
