Selca G83 Deep drilling fixed cycle with tool retraction for chip discharge
Programming
G83 [X... Y...] Z... J... I... [Q...] [K...] [F...] [D0=...] [D7=1] [D8=...] [D9=1]
Parameters
| Parameter | Description |
|---|---|
| X,Y | hole coordinates. |
| Z | hole bottom plane. |
| I | depth increment prior to (tool) return for chip discharge. |
| J | hole starting plane and tool retraction plane for chip discharge. |
| Q | Z-axis clearance plane. |
| K | dwell time for cheap breakage at the each increment (in tenths of a second). |
| F | feed rate. |
| D0= | when descending after a chip discharge, tool rapid move changes to the programmed feed rate at a distance of D0 mm from the previous depth. |
| D7=1 | tool retracts to theQplane for chip discharge. |
| D8= | scaling factor for rapid positioning feed (value include between 0 and 1;D8=1 by default). (Only for S4000 CNCs). |
| D9=1 | never mind where the machine is, the cycle is execute in XY position, without to programming XY (D9=0 by default). |
Enabled: until a new fixed cycle or a G80 is programmed.
