Selca G40 Exit from profile and cutter compensation disable

Selca G40 Exit from profile and cutter compensation disable

Programming

G40 [K...] [X... Y...]

Parameters

ParameterDescription
Kselects profile exit mode:
K1: automatic profile exit with a straight line perpendicular to the last programmed element.
K2: automatic profile exit with a semicircle tangent to the last programmed element. If K is omitted, profile exit will not be automatic and must be programmed.
X, Ycoordinates of the point to be reached after exiting the profile. Cutter compensation is disabled at this point.