Sinumerik Alarm 300750 Axis %1 drive %2 parameterization error in speed control adaption


Sinumerik Alarm 300750 Axis %1 drive %2 parameterization error in speed control adaption

Parameters:
%1 = NC axis number
%2 = Drive number

Definitions:
The upper adaptation speed MD 1412: $MD_SPEEDCTRL_ADAPTSPEED_2 (upper adaption speed) is less than the lower adaptation speed MD 1411: $MD_SPEEDCTRL_ADAPTSPEED_1 (lower adaption speed).

Reactions:
– NC not ready.
– Channel not ready.
– Channel not ready.
– NC Stop on alarm.
– NC Start disable in this channel.
– The NC switches to follow-up mode.
– Alarm display.
– Interface signals are set.

Remedy:
Please inform the authorized personnel/service department. $MD_SPEEDCTRL_ADAPTSPEED_2 (upper adaption speed) and MD 1411: $MD_SPEEDCTRL_ADAPTSPEED_1 (lower adaption speed).

Program Continuation:
Clear alarm with the RESET key in all channels. Restart part program.

References

  1. Siemens Diagnostics Guide by Siemens
Sinumerik Alarm 300750 Axis %1 drive %2 parameterization error in speed control adaption