Sinumerik Alarm 1030 System error in link module error code %1 error type %2


Sinumerik Alarm 1030 System error in link module error code %1 error type %2

Parameters:
%1 = Hex-Zahl Link-Error
%2 = Hex-Zahl Link-Error-Type

Definitions:
This alarm is not a user error. An internal error has occurred in the software of the link module.Two parameters are output with this error for debugging purposes. They provide information about the cause and location of the error.

Reactions:
– Alarm display.
– Interface signals are set.
– NC not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.

Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see alarm 1000)

Program Continuation:
Switch control OFF – ON.

References

  1. Siemens Diagnostics Guide by Siemens
Sinumerik Alarm 1030 System error in link module error code %1 error type %2