Okuma Alarm-B 2534 LBB turret rotation impossible

Okuma Alarm-B 2534 LBB turret rotation impossible
It instructed when it was not possible to instruct in LBB turn. (G269)


1->There is no long bore bar specification.
2->It instructed during the fixed cycle.
3->It instructed no Nose-R correction mode.
4->It instructed during the LAP cycle.
5->It instructed in the slope processing mode.
6->It instructed W axis control mode.
7->It instructed X axis mirror image coordinate system.
8->It instructed the translation, the rotational transfer, and in the COPY mode of coordinates.
9->It instructed while the tailstock and connecting the swinging stop.
101->T1 or the T3 position was directed stepping over.
102->It is not B axial mode.
103->It is not unclamping of B axis.
104->Z axis is not in the range of tool-post turn OK.
105->X axis is not a plus changeability limit.
106->The YS axis is not at a main spindle center position.
107->It instructed in X axis or Z axis.
108->It instructed excluding G00 and G01.
109->In the LBB attachment state, without auxiliary tool.

Probable Faulty Locations
Program error

Measures to Take
The part that corresponds to the above-mentioned code is corrected.

Okuma Alarm-B 2534 LBB turret rotation impossible