Okuma Alarm-B 2385 LAP Entry in LAP


Okuma Alarm-B 2385 LAP Entry in LAP
During LAP control, LAP command (G85, G86, G87 and G88) is designated.
G85: Calls rough bar turning cycle.
G86: Calls rough copy turning cycle.
G87: Calls finish turning cycle.
G88: Calls continuous thread cutting cycle.

Object
SYSTEM

Probable Faulty Locations
Program error
Program Example:

NLAP1 G81
:
G85 NLAP2
:
G80

Measures to Take
Check the G85, G86, G87 and G88 commands.
In the example program above, the G85 command is designated within the LAP mode; delete the G85 block.

Okuma Alarm-B 2385 LAP Entry in LAP