Okuma Alarm-A 1833 Tow-along steady rest unclamp interlock
Code
1->The steady rest unclamp command was issued during spindle rotation.
2->The steady rest unclamp command was issued without locating the XA-axis in the positive variable limit.
3->The steady rest unclamp command was issued without locating the steady rest at the retract end.
4->The steady rest unclamp command was issued when the steady rest clamp/unclamp confirmation signals were both ON or OFF.
5->The steady rest unclamp command was issued in the Y-axis control mode.
6->The steady rest clamp/unclamp command was issued when the steady rest was not clamp/unclamp state.
7->The steady rest unclamp command was issued when the steady rest was not unclamp state.
8->The steady rest unclamp command was issued without locating the ZA-axis at the concatenation carriage return place.
9->The steady rest unclamp command was issued when the turret position was not angle 90 or turret tool was not Dummy tool (or no tool).