Okuma Alarm-B 2675 Tool posture command error
There is an error in the tool direction command.
1: It was specified an axis angle mode in a tool direction mode.
2: A tool direction mode is specified although it is not included in the specifications.
4: It was specified a tool direction mode in an axis angle mode.
5: It was specified besides D0/D1 in the tool center point control mode(G255).
6: It was specified I,J,K in a G00/G01 order in an axis angle mode.
7: It was specified A,B,C in a G00/G01 order in a tool direction mode.
8: It was specified I,J,K in a G02/G03 order in a tool direction mode.
Probable Faulty Locations
Measures to Take
Correct the program.