Sinumerik Alarm 26081 Channel %1 axis trigger of axis %2 was activated, but axis is not PLC- controlled


Sinumerik Alarm 26081 Channel %1 axis trigger of axis %2 was activated, but axis is not PLC- controlled

Parameters:
%1 = Channel
%2 = Axis, spindle

Definitions:
The axis trigger for single axis was initiated. However, the axis is not PLC-controlled at the trigger time (therefore no single axis) or the position became invalid.

Reactions:
– Alarm display.

Remedy:
Preset axis PLC-controlled (declare single axis).

Program Continuation:
Clear alarm with the Delete key or NC START.

References

  1. Siemens Diagnostics Guide by Siemens
Sinumerik Alarm 26081 Channel %1 axis trigger of axis %2 was activated, but axis is not PLC- controlled