Okuma Alarm-D 4898 Power save ON
The machine was put in energy saving mode by the energy save command from the peripheral equipment.
The machine was put in energy saving mode because the program had not been executed in AUTO mode with the single block
OFF within the time specified in units of minutes (initially, 30) by M/C user parameter No. 5 ‘Power Save’, bit 2 xis was in reset mode.
‘Power Save Time’.
The time specified in hexadecimal notation in units of minutes by M/C user parameter No. 5 ‘Power Save’, bit 2 ‘Power Save Time’
Examples of operation:
The machine was not restarted within the preset time after the end of program.
Nothing was done for the preset time after the machine stopped continuous operation due to an alarm.
Measures to Take
1) Reset the NC unit.