Okuma Alarm-C 3213 DNC Text transmission error
During text transmission, an error which does not allow transmission has occurred.
Five characters of transfer command or transfer sub command of the transmitted text
Content differs depending on the text. Refer to the following for details.
In case of D,NCP
1->File reading impossible during transmission in the single mode. (Refer to the error message at the console line for details.)
2->In the single mode, program to be transferred is not in the memory. (In this case, D,NCP is not transmitted.)
3->In the single mode, main program to be transferred is not selected. (In this case, D,NCP is not transmitted.)
Probable Faulty Locations
Varies depending on the text;
1)Operation error the CNC side
2)Timing error in operation