Okuma Alarm-B 2544 TOOL-ID TOOL DATA
Concerning TOOL-ID specification, when it read and wrote tool data of every kind by the System Variable, since tool data had not been set correctly, it could not read and write.
Or, since it was not appointed correctly, it could not read and write.
None -> Though tool data did not exist, it read tool data by the System Variable. It has written form revised quantity, tool length, tool life span data using a systematic variable by the condition which a tool number was not specified.
1 -> When it wrote tool data of turret by the System Variable, it performed an entry of tool kind (revised data identifier) which it can not install on the turret.
2 -> It has written the tool number which it already uses by other tool.
3 -> When it wrote tool data in a magazine, dummy pot appointment was turned into the magazine pot which is not a vacancy pot.
4 -> When it writes tool data in a magazine, it has written data in a magazine pot of dummy pot appointment.