Haas Settings

Haas Setting 21 Rapid Override Lock Haas Setting Description The axis rapid override buttons are disabled when this setting is turned ON.

Haas Setting 20 Spindle Override Lock Haas Setting Description The spindle speed override buttons will be disabled when this setting is turned ON.

Haas Setting 19 Feedrate Override Lock Haas Setting Description The feedrate override buttons will be disabled when this setting is turned ON.

Haas Setting 18 Block Delete Lock Out Haas Setting Description The Block Delete feature will not be available when this setting is ON.

Haas Setting 17 Opt Stop Lock Out Haas Setting Description The Optional Stop feature will not be available when this setting is on.

Haas Setting 16 Dry Run Lock Out Haas Setting Description The Dry Run feature will not be available when this setting is turned ON.

Haas Setting 15 H & T Code Agreement Haas Setting Description Turning this setting ON has the machine check to ensure that the H offset code matches the tool in…

Haas Setting 14 Synchronization Haas Setting Description This changes the synchronization protocol between sender and receiver for the first serial port (RS-232). This setting must match the transfer rate from…

Haas Setting 13 Stop Bit Haas Setting Description This setting designates the number of stop bits for the first serial port (RS-232). It can be 1 or 2. This setting…

Haas Setting 12 Parity Select Haas Setting Description This setting defines parity for the first serial port (RS-232). When set to None, no parity bit is added to the serial…

Haas Setting 11 Baud Rate Select Haas Setting Description This setting allows the operator to change the rate at which data is transferred to/from the first serial port (RS-232). This…

Haas Setting 10 Limit Rapid At 50% Haas Setting Description Turning this setting “ON” will limit the machine to 50% of its fastest non-cutting axis motion (rapids). This means, if…

Haas Setting 9 Dimensioning Haas Setting Description This setting selects between inch and metric mode. When it is set to “INCH”, the programmed units for X, Y, and Z are…

Haas Setting 8 Prog Memory Lock Haas Setting Description This setting locks out the memory editing functions (Alter, Insert, etc.) when it is set to “ON”.

Haas Setting 7 Parameter Lock Haas Setting Description Turning this Setting “ON” will stop the parameters from being changed, except for parameters 81-100. Note: When the control is powered up,…

Haas Setting 6 Front Panel Lock Haas Setting Description This Setting disables the Spindle CW and CCW buttons when it is set to “ON”.

Haas Setting 5 Graphics Drill Point Haas Setting Description This setting changes the way a program is viewed in Graphics mode. When it is ON, motion in the Z-axis will…

Haas Setting 4 Graphics Rapid Path Haas Setting Description This setting changes the way a program is viewed in the Graphics mode. When it is OFF, rapid (non-cutting tool motions…

Haas Setting 2 Power Off At M30 Haas Setting Description Powers down the machine at the end of a program (M30) if this setting is set to “On”. The machine…

Haas Setting 1 Auto Power Off Timer Haas Setting Description This setting is used to power-down the machine when it has not been used for some time. The value entered…